Dan at Cecco Motorsports

Call

Dan at Cecco Motorsports Hello, I’m Dan the Powersports Tech at Cecco Motorsports.

This was an great project. New bushings through all the control arms, sway bar bushings and all 4 wheel bearings. Instal...
10/21/2026

This was an great project. New bushings through all the control arms, sway bar bushings and all 4 wheel bearings. Installed a new HD driveshaft and carrier bearing and oil filter relocation kit. Then we installed a graphics kit to complete this 2024 Polaris Xpedition ADV 1000.

This RzR 800 came in with a bunch of loose joints. Once on the lift we installed new control arm bushings, wheel bearing...
10/16/2026

This RzR 800 came in with a bunch of loose joints. Once on the lift we installed new control arm bushings, wheel bearings, a balljoint, front differential with drive shaft replacement as well and new wheel spacers. With winter on its way setup to get your machine prepped in its down time or slower riding season to get tightened up.

Yamaha RMax 1000 oil lines sit on the skid pan incased in any debris left over from your last ride or even a wash. This ...
10/06/2026

Yamaha RMax 1000 oil lines sit on the skid pan incased in any debris left over from your last ride or even a wash. This debris acts like a sand paper on your lines wearing through till it bursts and lunches your engine. Fortunately we’ve go a cure, a couple hours work and you have no more worries of this problem affecting you.

Sometimes overheating isn’t always a part failure. Which most machines the radiator isn’t very open for cleaning. Then y...
09/28/2026

Sometimes overheating isn’t always a part failure. Which most machines the radiator isn’t very open for cleaning. Then you have to disassemble a little bit more to get full access.

Good ol’ Yamaha Big Bear 400 didn’t want to move so well. Had to replace a shift pawl and clutch.  Now this Bear is read...
09/23/2026

Good ol’ Yamaha Big Bear 400 didn’t want to move so well. Had to replace a shift pawl and clutch. Now this Bear is ready to run.

First motor rebuild for the 2027 race season. Right case half was cracked well over half way across the entire surface. ...
09/17/2026

First motor rebuild for the 2027 race season. Right case half was cracked well over half way across the entire surface. All new bearings, crank, piston. Need you motor rebuilt or just freshened up. We got your back.

Full carburetor cleaning and rebuild for this Suzuki Vinson 500. Fresh air filter to help the machine breathe much freer...
09/15/2026

Full carburetor cleaning and rebuild for this Suzuki Vinson 500. Fresh air filter to help the machine breathe much freer.

Rzr 1000 came in with a blown reverse chain. Replaced the chain with a double chain setup, also replaced an axle and whe...
09/08/2026

Rzr 1000 came in with a blown reverse chain. Replaced the chain with a double chain setup, also replaced an axle and wheel bearing. With new brakes to stop much better.

Polaris Sportman 700 Twin that needed some TLC.  Got it fitted with new axles bearings and control arm bushings to tight...
08/29/2026

Polaris Sportman 700 Twin that needed some TLC. Got it fitted with new axles bearings and control arm bushings to tight up the ride. Also replaced a worn radiator hose. Ready for the trail again

Address

8742 Pa. 61
Philadelphia, PA
17866

Telephone

+12672213519

Website

Alerts

Be the first to know and let us send you an email when Dan at Cecco Motorsports posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Sponsored

Share