10/23/2026
Public Service Information:
I'm writing this to raise awareness, not to insult or belittle those who do not know. I noticed not a lot of people are aware of how bulkheads work. Especially when installing our PF HOB Overflows, Eclipse, and Prodigy overflow boxes. I do get quite a few emails complaining that our Flex Hose will not screw on the bottom of the Bulkheads. Too many times to ignore. I understand most of these calls and emails are from people new to the hobby or basic plumbing (I myself am very novice to plumbing). SO I hope this article helps.
(Read on...)
The persistent belief that the bottom (external body) of a bulkhead is a "screw-on" connection rather than a "slip-in" connection is one of the most common and stubborn misunderstandings in plumbing and aquarium setups.
The external threads on a bulkhead are exclusively for the locking nut, but several visual and experiential factors cause people to mistakenly try to screw standard female PVC fittings directly onto them.
1. The Power of Visual Bias
The most obvious reason is simple visual assumption. When someone looks at the bottom of a bulkhead protruding from a tank or reservoir, they see a massive, highly visible set of external male threads. In standard plumbing logic, a male thread is meant to accept a female threaded fitting. It is counterintuitive for a beginner to look at a threaded pipe and realize they are supposed to ignore those threads entirely and slide a smooth PVC pipe into the smooth interior core of the fitting.
2. Confusion Between Locking Threads and Plumbing Threads
People fail to realize that bulkhead external threads are non-standard proprietary or "plumber's" threads. They are flat, straight threads designed solely to tighten the locking nut and compress the rubber gasket against the tank wall. They do not feature the National Pipe Thread (NPT) taper required to create a watertight hydraulic seal with standard plumbing fittings.
3. The Coincidental "Close Fit"
A major driver of this myth is that standard female PVC fittings will often casually catch a thread or two on the outside of a bulkhead if forced. Because a 1-inch female PVC coupling might physically start to screw onto the outside of a 1-inch bulkhead, people assume it is meant to go there. They cross-thread or force the fitting on, apply massive amounts of Teflon tape or silicone to stop the inevitable leaks, and inadvertently propagate the idea that it "can" be done—even though it frequently splits the plastic or fails under pressure.
4. Overlooking Internal Configurations
Bulkheads actually come in four internal styles, which dictate how you connect your pipes:
• Slip x Slip: Smooth on both inside ends; pipes must be glued in with PVC cement.
• Thread x Thread: Tapered female NPT threads on the inside of both ends.
• Slip x Thread / Thread x Slip: A mix of smooth and internal threads.
Because people do not look inside the barrel of the bulkhead, they miss the smooth slip socket or the internal NPT threads where the actual connection is engineered to happen.