DALUA

11/03/2026

🐠 Adding a new fish to your reef tank? Don’t rush the acclimation!

Drip acclimation can help gradually adjust your fish to the water conditions in your aquarium, reducing sudden changes in water chemistry.

💧 Here’s how to do it:

1️⃣ Float the sealed bag to help equalise temperature, following the supplier’s instructions.

2️⃣ Transfer the fish and transport water into a clean acclimation container.

3️⃣ Start a slow drip of aquarium water into the container using airline tubing.

4️⃣ Monitor the water level and follow a suitable acclimation time for the fish and supplier’s guidance.

5️⃣ Once acclimated, transfer the fish into your tank using a net or specimen container. Avoid adding transport water to your aquarium.

⚠️ Important: If the fish has been shipped for a long time, opening the bag can change the water chemistry and cause ammonia to become more toxic. In these situations, prolonged drip acclimation may do more harm than good. Follow the supplier’s recommended procedure.

💡 A calm, controlled introduction is key to giving your new fish the best start!

11/03/2026

🌱 Want that lush green carpet in your aquarium? Meet Monte Carlo! 👀

Monte Carlo is a popular carpeting plant that can transform the foreground of your aquascape into a beautiful green lawn.

🌿 How do you get it to carpet?

* Plant small portions across the substrate, leaving space between them.
* Provide adequate lighting to encourage compact growth.
* Make sure there’s enough nutrients available.
* Keep up with regular trimming to encourage dense, low growth.

💡 Pro tip: Don’t plant it all in one big clump. Spreading smaller portions across the foreground gives the plant more room to grow and fill in.

With the right conditions and a little patience, those small patches can turn into a stunning green carpet!

11/02/2026

🪸 Fragging a coral is only half the job!

Once you’ve fragged a coral, the next step is just as important — monitoring how it recovers. 👀

🔍 What should you look for?

* ✅ Tissue staying healthy around the cut
* ✅ Normal polyp extension as it recovers
* ⚠️ Signs of tissue recession or unusual discolouration
* ⚠️ Frags becoming loose or unstable on their plugs

💡 Keep your water parameters stable, provide appropriate flow, and avoid constantly moving or handling the frag.

Remember, different corals recover at different rates, so give them time and watch for changes.

Fragging doesn’t end at the cut — recovery matters! 🌊

11/02/2026

🌿 STOP BURYING YOUR JAVA FERN! 👀

Java Fern is a rhizome plant, which means it grows from a thick horizontal stem called a rhizome.

🌱 Here’s the important part:

* ❌ Don’t bury the rhizome in your substrate — it can rot.
* ✅ Attach it to driftwood or rocks using aquarium-safe glue or thread.
* 🌿 Let the roots grow naturally and anchor themselves over time.

Java Fern is a fantastic low-maintenance plant, making it a great choice for beginners!

💡 Remember: Keep the rhizome exposed, and let your Java Fern do its thing!

10/31/2026

🌊🪸 Gyre mode vs Random mode — which flow is best for your reef?

Your wave maker does more than just move water around! The mode you choose can change how water travels through your aquarium.

🌊 GYRE MODE – creates a more consistent, sweeping flow pattern that moves water around the tank. It can help circulate water through your rockwork and reduce dead spots when positioned correctly.

🌪️ RANDOM MODE – varies the flow pattern over time, creating changing currents rather than one predictable direction.

🪸 Which should you use? It depends on your tank layout and the corals you’re keeping. Some corals prefer gentler, consistent movement, while others benefit from more varied flow.

💡 Pro tip: Watch your corals and check for areas where debris settles. You want good circulation without blasting corals or creating a sandstorm!

There’s no single perfect setting for every reef — it’s all about finding the right flow for your setup. 🔥

10/31/2026

🌿😩 Think hair algae is bad? Meet its stubborn cousin: tuft algae!

Ever had algae growing in short, dense tufts that seem almost impossible to remove? You might be dealing with a type of tuft-forming algae that’s much tougher to get rid of than ordinary hair algae!

🔍 Hard to remove – it can cling tightly to rocks, decor and plant leaves.

🧹 Manual removal helps – carefully pull or brush off what you can without damaging the surface underneath.

💡 Review your lighting – excessive intensity or long photoperiods may contribute to algae growth.

🧪 Check your tank conditions – look at nutrient balance, maintenance and plant health rather than guessing.

⚠️ Identify it first! Several different algae types can look like dense tufts, and the best treatment depends on what you’re dealing with.

The key is to remove as much as possible, work out what’s encouraging the growth, and stay consistent with your maintenance.

Have you battled this stubborn stuff in your tank? 👀👇

10/30/2026

10/30/2026

🪸👀 Your Duncan coral might be telling you something about your reef tank!

Duncan corals are fascinating to watch because their fleshy heads and tentacles can give you clues about how they’re responding to their environment.

🌸 Open and extended? Your Duncan may be comfortable with its current conditions.

😬 Staying closed? Something could be bothering it, from changing water parameters to unsuitable flow or lighting.

🧪 Not looking like its usual self? Check your salinity, temperature, alkalinity and other key reef parameters before making adjustments.

🌊 Watch the flow too! Duncan corals generally appreciate gentle to moderate, indirect flow that lets their tentacles move without being blasted.

⚠️ Remember, a Duncan isn’t a perfect water-quality test. It can close up for several reasons, so look for patterns and test your water rather than guessing!

Learn what your corals look like when they’re happy, and you’ll be quicker to notice when something changes. 🪸💚

10/29/2026

🌿😱 Your new aquarium plants are melting… should you panic?!

You’ve just planted your new aquascape, and suddenly the leaves are turning brown, transparent or falling apart. What’s going on?

It could be plant melt — and it’s often part of the transition to a new environment!

🌱 Emersed vs submerged growth – many nursery plants are grown above water, so their existing leaves may struggle when fully submerged.

🍃 Old leaves break down – the plant may lose its original foliage while adapting to underwater growth.

🌿 New growth is the good sign – look for fresh leaves and healthy shoots as the plant adjusts.

💧 Keep conditions stable – avoid constantly moving plants or making drastic changes to lighting and nutrients.

✂️ Remove decaying leaves to keep the tank tidy, but don’t pull out the whole plant too quickly if the roots and growing points are still healthy.

⚠️ Not all melting is normal! Poor conditions, damage or nutrient issues can also cause plant decline.

Be patient, watch for new growth, and give your plants time to adapt! 🌱💚

10/29/2026

🌊🟤 Struggling with diatoms in your reef tank? Check your flow!

That dusty brown coating on your rocks and sand can be frustrating, especially in a newer reef tank. But did you know your water flow can play a role?

🌊 Reduce dead spots – good circulation helps prevent debris from settling and accumulating in areas with little movement.

🪸 Keep water moving – appropriate flow helps carry suspended particles towards your filtration system.

🔍 Check your dead zones – if detritus is collecting in corners or behind rocks, you may need to adjust your wave maker’s direction.

⚠️ But flow isn’t a magic cure! Diatoms often appear in new tanks and can be associated with available silicate. Increasing flow alone won’t eliminate the underlying cause.

The goal is balanced circulation throughout your reef, without blasting your corals or creating sandstorms! 😂

🌊 Check your flow, keep up with maintenance and give your tank time to mature.